It is stored in a single integrated circuit which is dedicated to performing a particular task and execute one specific application. It is specially designed circuits for embedded applications and is widely used in automatically controlled electronic devices.
A microprocessor is a controlling unit of a micro-computer wrapped inside a small chip. It is a single Integrated Circuit in which several functions are combined. Skip to content.
Microprocessor is used in Personal Computers whereas Micro Controller is used in an embedded system. Microprocessor uses an external bus to interface to RAM, ROM, and other peripherals, on the other hand, Microcontroller uses an internal controlling bus. Microprocessors are based on Von Neumann model Micro controllers are based on Harvard architecture Microprocessor is complicated and expensive, with a large number of instructions to process but Microcontroller is inexpensive and straightforward with fewer instructions to process.
If you mean greater more Comparision between motorola And Intel The was a microprocessor, the was a floating point co-processor chip which could be used with the The principle difference is the width of the external data bus; on the it was 16 bit, on the it was 8 bit. They are identical except the program memory of the is one time programmable usually at the factory and the is user reprogrammable.
There are several differences between the and the Two notable differences: 1. The most significant difference between the Intel and microprocessors is that the is an 8-bit system and the is a bit system. This difference allows the system to have a much larger set of operational instructions and can make calculations to more significant places.
Note: the processor does have two bit registers. The pointer and the program counter. Log in. Electronics Engineering. Intel and Study now. See Answer. Best Answer. Study guides. Physics 20 cards. A wave has a frequency of hertz what is the period of the wave. In which material does sound travel the fastest.
In this type of wave particles of the medium vibrate perpendicularly to the direction of the wave itself. A 5 ohm resistor a 10 ohm resistor and a 15 ohm resistor are connected in series to a volt power source What is the amount of current flowing between the 5 ohm resistor and the 10 ohm resistor. Electrical Engineering 21 cards. Cannot be used in compact systems and hence inefficient Can be used in compact systems and hence it is an efficient technique Cost of the entire system increases Cost of the entire system is low Due to external components, the entire power consumption is high.
Hence it is not suitable to used with devices running on stored power like batteries. Since external components are low, total power consumption is less and can be used with devices running on stored power like batteries.
Most of the microprocessors do not have power saving features. Most of the micro controllers have power saving modes like idle mode and power saving mode. This helps to reduce power consumption even further. Since components are internal, most of the operations are internal instruction, hence speed is fast.
0コメント